Wollongong, Shellharbour and Kiama
Ceiling Re-Sheeting in Wollongong
Ceiling re-sheeting in Wollongong for a single ceiling or one room's walls when patching no longer makes sense: sagging or crumbling ceilings, repeated leaks, old lath-and-plaster, or a ceiling covered in failed patches.
Call (02) 4263 0622What our ceiling re-sheeting includes
- Removal and disposal of old plaster
- New plasterboard, including wet-area board where needed
- Tape, stop and sand to paint-ready
- Square-set and shadow-line work on request
- Rubbish removed and room vacuumed
Prices
A standard 3.5 x 4 m bedroom ceiling is $1,800 to $2,600 including GST, and the walls of one room $2,400 to $3,600. Add 20 to 35% for old lath-and-plaster and 15% for ceilings over 3 metres.
Job size
We take on plastering jobs valued at $5,000 or less including GST, which covers single ceilings, one room's walls and almost all repairs. Whole-room, multi-room and whole-house re-sheets are bigger renovation jobs, and we will point you to a licensed builder or contractor for those.
Patch or replace?
Patch if the damage is under about a third of the ceiling, the surrounding plaster is sound, there is no sag, it is dry and the cornice is intact. Replace if it is sagging, soft or crumbling, has multiple failed patches, covers more than a third of the ceiling, is failing lath, or has been wet repeatedly.
Old fibro and asbestos
Older Illawarra homes may have fibro sheeting, ceiling tiles or joint compound containing asbestos. If we suspect it, we stop, explain, and recommend a licensed assessor or removalist. We re-sheet once it has been tested and cleared.
What happens on the day
We walk the room with you and confirm the scope. Furniture goes out or is centred and covered, the floor is sheeted wall to wall, and the doorway is taped and zipped so we work towards the door. The circuit is isolated and the ceiling propped. The old cornice and sheet come down in cut sections, old fixings are pulled, and battens and joists are checked, with rotten or split timber replaced and extra battens added where centres are over 450 mm. New sheets go up with joins on battens and screws at 200 mm centres, then tape, three coats, sanding and primer.
Visits and drying time
Usually three visits: removal and new sheet on day one, coats and sanding over the next two to three days, then clean-up and prime. Coats need 45 to 90 minutes to set with Easy-Fill, longer in cold weather, and we never sand a coat that has not gone off.
Dust
Expect some, but contained. The doorway is zipped, the floor sheeted, a fan or negative-air unit sits at the window where the room allows, cutting is done outside where possible, and we use a vacuum on the sander. You should find a fine film on the hallway side of the door and nothing more. Offcuts are bagged and taken away.
What we find above old lath
Loose-fill insulation (in some 1960s and 70s homes it may be vermiculite, which we treat as suspect until tested), rodent and possum nests, sometimes old perished wiring run across the joists, and occasionally a disconnected flue or water pipe. We photograph it all and tell you what needs an electrician or a test before we sheet, and whether the old insulation can go back.
Recent ceiling re-sheeting jobs
| Suburb | Job | Time | Price inc GST |
|---|---|---|---|
| Berkeley | Possum-damaged lounge ceiling 1980s brick veneer, 5.4 x 4.0 m. Years of possums soaked the sheet; three sheets had dropped 35 mm and a corner was hanging. Propped, 4 sheets and 6 bags of soiled insulation removed, frame treated, new batts, re-sheeted, new 90 mm cove, set and primed. The owner had the roof line sealed the same week. | 3 visits over 8 days | $3,150 |
| Unanderra | Valley leak in a 1950s kitchen ceiling Fibro and tile. Failed valley iron, with water tracking 2 m sideways along a batten. After the roofer fixed the valley, the sheet and old lath came out, the frame was treated, then 10 mm moisture-resistant board, new 55 mm cove, set and primed. | 3 visits over 11 days | $2,890 |
| Port Kembla | Old fibro laundry ceiling 1950s home with possible asbestos. The owner arranged testing and licensed removal first, then 3 m² was re-sheeted. | 1.5 days | $1,350 |
| Thirroul | Sagging 1920s hall ceiling Lath-and-plaster sagging about 30 mm with three old patch jobs. Removed 5 m² of failed lath, added battens, re-sheeted in 10 mm board. | 2 days | $1,480 |
Our guarantee
Twelve months on workmanship. If a patch cracks inside that period and the cause is not movement, a leak we were not told about, or someone else's work above us, we come back and fix it free. The guarantee covers our plastering, not the roof, plumbing or waterproofing, and we say so in writing.
Areas we cover
Ceiling Re-Sheeting questions
How long does a ceiling re-sheet take?
Usually three visits over about a week: removal and new sheet on day one, coats and sanding over the next two to three days, then clean-up and primer. Add drying time first if the area was wet.
Is re-sheeting worth it over patching?
When the ceiling is sagging, crumbling, repeatedly wet or full of failed patches, yes. Patching is cheaper only while the surrounding plaster is sound.